Search results for "Concentration effect"
showing 10 items of 80 documents
Shear Induced Demixing and Rheological Behavior of Aqueous Solutions of Poly(N-isopropylacrylamide)
2003
The interrelation between the phase separation behavior and the rheological performance of aqueous solutions of high molecular weight (M w = 1 600 kg/mol) poly(N-isopropylacrylamide) was investigated. The system demixes upon heating and the cloud point temperature, T cp decreases steadily with rising polymer concentration up to 10 wt.-%. The application of shear supports phase separation and reduces T cp markedly. This observation is interpreted in terms of destruction of intersegmental clusters formed in the quiescent state owing to favorable interactions. Intrinsic viscosities and Huggins coefficients as well as the viscosities, η at higher polymer concentrations are closely connected wit…
ZnO nanorod arrays fabrication via chemical bath deposition: Ligand concentration effect study
2010
A new ligand, N, N, N', N'-tetramethylethylenediamine, has been used to grow ZnO nanorods on silicon substrates via a two steps approach. A preliminary seeding on silicon substrates has been combined with chemical bath deposition using a Zinc acetate - N, N, N', N'-tetramethylethylenediamine aqueous solution. The used diamino ligand has been selected as Zn(2+) complexing agent and the related hydrolysis generates the reacting ions (Zn(2-) and OH(-)) responsible for the ZnO growth. The seed layer has been annealed at low temperature (<200 degrees C) and the ZnO nanorods have been grown on this ZnO amorphous layer. There is experimental evidence that the ligand concentration (ranging from 5 t…
Static and dynamic light scattering by aqueous polyelectrolyte solutions: effect of molecular weight, charge density and added salt
1990
Abstract Aqueous solutions of quaternized poly(2-vinylpyridine) were investigated by static (SLS) and dynamic (DLS) light scattering over a wide range of polyelectrolyte, c pe , and salt concentrations, c s (10 −3 ≤ c pe ≤ 10 2 gl −1 , 10 −5.5 ≤ c s ≤ 10 −1 moll −1 ). Using DLS the cooperative diffusion coefficient D was measured as a function of c pe and c s . D exhibits a characteristic behaviour in each of three different concentration regimes. In the ‘dilute lattice’ regime, where λ = c pe c s ⪡ 1 , one diffusion coefficient is observed. In the transition regime, where λ ≈ 1, D increases with increasing polyelectrolyte concentration and a slow diffusive mode gradually appears. For λ ⪢ 1…
Effect of pH, cation concentration and sorbent concentration on cadmium and copper removal by a granular activated carbon
1999
The single adsorption of cadmium and copper from aqueous solutions has been investigated on Darco 12-20 mesh granular activated carbon for a wide range of experimental conditions: pH, metal concentration and carbon concentration. The results showed the efficiency of the activated carbon as sorbent for both metals. Metal removal increases on raising pH and carbon concentration, and decreases on raising the initial metal concentration. The adsorption processes have been modelled using the surface complex formation (SCF) Triple Layer Model (TLM) with a single surface bidentate species or with an overall surface species with fractional stoichiometry. Bidentate stoichiometry considering pH, meta…
Volumes and compressibilities of pentanol in aqueous dodecyltrimethylammonium bromide solutions at 15, 25 and 35°C
1990
Ultrasonic velocities and densities of the water-dodecyltrimethylammonium bromide (DTAB)-pentanol (PentOH) ternary system were measured at 15, 25 and 35°C as a function of the surfactant and alcohol concentrations. The apparent molar volumes and isentropic compressibilities of PentOH were calculated. The standard partial molar volumes increase with surfactant concentration continuously whereas the standard partial molar isentropic compressibilities show sharp changes in slope at about 0.25 mol-kg−1 DTAB, which can be ascribed to a micellar structural transition. The volume data for alcohol in micellar solutions were treated by a model reported for the distribution of polar additives between…
Ionomers in solution: 1. Viscometric and chromatographic studies in cononsolvent and cosolvent mixtures
1997
Abstract The viscosity and elution behaviour of polystyrene sulfonate ionomers with varying ionic content has been studied in the pure solvents chloroform (CHL), tetrahydrofuran (THF), dioxan (DIO), ethyl acetate (EA) and dimethylformamide (DMF) as well as in their cononsolvent mixtures CHL/THF (50:50), DIO/CHL (75:25) and in the cosolvent mixture EA/DMF (50:50). In the pure solvents with low dielectric constant the reduced viscosities of ionomers are lower at low concentrations and higher at moderate ones than the respective viscosities of the polystyrene precursor. These results can be explained by formation of intramolecular and intermolecular associations. Moreover, differences in visco…
Identification of off-flavor compounds in high-density polyethylene (HDPE) with different amounts of abscents
1998
The use of synthetic pipes for drinking water distribution has increased. High desnity polyethylene (HPDE) is preferred because of its favorable mechanical properties, ease of handling during manufacturing, and low permeability to external contaminants. Off-flavor drinking water is a problem with plastic pipes. The compounds causing off-flavors are mainly carbonyl compounds. A combined zeolite called Abscents is used to eliminate odors and to remove odor-causing compounds. In this study, four different amounts of Abscents were added to raw HDPE pellets, and the influence on the off-flavor properties were analyzed. When the maximum amount of Abscents was added, almost all the carbonyl compou…
Determination of rate constants of ion transfer kinetics across immiscible electrolyte solutions
1998
Abstract The rotating diffusion cell was used to study ion transfer across the interface between two immiscible electrolyte solutions. Tetrabutylammonium was chosen as the transferring cation and lithium chloride as the supporting electrolyte in aqueous phase. Tetrabutylammonium tetrakis-(4-fluorophenyl)-borate in 2-nitrophenyl-octylether was used as the organic electrolyte solution supported in the porous membrane. The quasi-steady state current–voltage curves were measured both by applying potential steps and by imposing a slow potential sweep. The analysis of experimental results was based on the comparison with the theoretical current–voltage curves and on the Koutecky–Levich plots. The…
Adsorption of proteins on porous and non-porous poly(ethyleneimine) and tentacle-type anion exchangers
1990
Abstract Adsorption isotherms of proteins [bovine serum albumin (BSA), soybean trypsin inhibitor and alcohol dehydrogenase] on anion exchangers were measured by on-line and off-line methods. The poly(ethyleneimine) (PEI) type and the tentacle-type materials exhibited principally different modes of adsorption. On thin layers of PEI, bonded to non-porous silica, BSA adsorption data corresponded to a monolayer of molecules, with 80% adsorbed side-on, with a high affinity constant for binding, and 20% adsorbed more weakly. With porous material, the amount of BSA bound per unit surface with high affinity was smaller. With tentacle-type anion exchangers, adsorption exceeded a monolayer by far, an…
Structural and dynamical investigation of gelation containing water-in-oil microemulsions
1996
The gelatin (Bloom 300)/water/AOT/n-heptane system has been investigated at fixed water/AOT molar ratioR (R=31.1) as a function of the gelatin content. Several experimental techniques (densitometry, refractometry, conductometry, rheology, dielectrometry, ultrasonics, hypersonics) have been used to investigate the role played by the gelatin molecule in the observed sol-gel transition above a critical gelatin content. The results appear consistent with the hypothesis of a rigid network of gelatin-water rods coated by surfactant molecules coexisting with gelatin-free AOT reversed micelles at the gelation point.